WELD-IN CROSS BAR FOR RISERLESS HANDLEBARS

WELD-IN CROSS BAR FOR RISERLESS HANDLEBARS

For 3.5" Wide Bar Builds
Laser-Cut Steel • USA Built

If you’re fabbing your own riserless bars, this is the little hunk of steel that keeps the whole setup from folding like a lawn chair. Weld it in, burn it hot, and you’ve got the backbone your front end’s been begging for. Strong, simple, and made to take whatever abuse you throw at it.

The cutout down the middle isn’t just for looks — it gives you a clean, smooth tunnel to run your wiring inside the bars so nothing’s flapping in the breeze or zip-tied like a rookie job. Real builders run their wires internal, and this piece makes it easy.

The bars shown are just to show you where this thing lives once you weld it in. The magic comes from your hands, your welder, and your bad ideas at 2 a.m.

Just steel, strength, and the start of a damn good set of bars.
Made in the USA.